COMPRO IP540 Manual de usuario descargar pdf (Pagina 55)

6-9Network SettingsNetwork Settings

Chapter 6: Conguration

Advanced

Adjust the advanced network settings here.

DNS server

Set the DNS server address to be via DHCP or choose to use user-specied DNS address.

NTP Conguration

Set the NTP (Network Time Protocol) server address to ensure the clock of the camera system is

synchronized to show accurate time. To synchronize camera clock via NTP server, choose either to obtain

NTP server address via DHCP server whose address needs to be provided manually, or to use an external/

public NTP server whose default address is set as pool.ntp.org.

HTTP server

Set the HTTP port for your IP camera to be viewed and controlled from the internet. The default port is 80.

Valid port numbers are between 1 and 32767. If you need to use port forwarding, please refer to the Port

Forwarding section in this manual.

RTSP server

Set the RTSP (Real-Time Streaming Protocol) port for your IP camera to enable the support of 3GPP

streaming for mobile phones. Default: 554. If you need to use port forwarding, please refer to the

troubleshooting section for port forwarding setup.

DDNS

ClickheretoenabletheDDNS(DynamicDomainNameService)serviceifyouareusingoating/dynamicIP

and want to tie your camera’s current IP address to a domain name. And instead of remembering a string of IP

address, you can use the easier-to-remember domain name to access your camera over the Internet. Compro

iDDNS service is recommended here for use. Or if you already have an account with DynDNS or no-ip, you can

also input its domain name here for easier access to your IP camera.

Note:

Compro's iDDNS server will automatically delete addresses that

haven't been updated for more than 3 months.

UPnP

Check here to enable/disable the UPnP feature on your IP camera installed on your local network. Also, you

can change the device name here. If your operating system supports Universal Plug and Play (UPnP™) feature

and DHCP is in use on current network, the Compro IP camera will be automatically detected and added to

My Network Places on your Windows. If you want to use the IGD (Internet Gateway Device) protocol on your

IP camera, please check the [Enable IGD] box to enable it.

Note:

If you want to enable the UPnP™ service on your Windows, please

executethe“AddorRemovePrograms”itemfoundin“ControlPanel”,

andafter“AddorRemovePrograms”windowappears,clickon“Add/

RemoveWindowsComponents”anddouble-clickon“Networking

Services”itemandcheck“UPnPUserInterface”boxandproceedto

install the component.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 89 90

Sin comentarios

COMPRO IP540 Manual de usuario Pagina 55